|
Field distributors for decentralized installation
Field distributors streamline drive connection with the
power supply system, DC 24 V control voltage and
fieldbus. They are based on bus interface technology with
additional connection technology for network distribution.
The field distributor is installed close to the motor, which
facilitates decentralized installation. Field distributors
Z.1, Z.3 and Z.7 are available as an option in an IP66
enclosure (protected against powerful water jets even if
water contains acidic or caustic additives). These field
distributors are the perfect match for MOVIMOT®
and MOVI-SWITCH® for fast, economical and
flexible decentralization of your system.
Components for decentralized drive engineering with IP66 or
IP67 enclosures
SEW-EURODRIVE components for decentralized drive engineering
are available with the IP66 enclosure as an option. Some are
also available with the IP67 enclosure. A range of
additional optional measures and the use of special
materials allow components to be used in extreme ambient
conditions, such as with acidic or caustic cleaning
additives. Option package for field distributors and
fieldbus interfaces:
- IP66/IP67 enclosure
- Stainless steel screw fittings pressure compensation
fitting
- M12 metal plug for fieldbus modules with M12 plug
connectors
Option package for MOVIMOT® and MOVI-SWITCH®:
- Drives with a drain hole
- OS surface protection
- IP66 terminal box with or without pressure
compensation fitting
- Optimized cable entry position
- Increased resistance to condensation
- Stainless steel fittings
Fieldbus interfaces
Type MF
Optional MF.. fieldbus interfaces allow MOVIMOT®
and MOVI-SWITCH® drives to connect to a
standardized fieldbus system. These fieldbus interfaces not
only allow for controlling MOVIMOT® and MOVI-SWITCH®
drives, but also for reading sensor signals as well as
controlling actuators via the digital input and output
terminals. All fieldbus interfaces and field distributors
come with the IP65 enclosure as standard. The fieldbus
interfaces may be mounted, as required, directly on the
drive, offset in the field, or in the field distributor. The
following fieldbus interfaces are available:
Type MQ
The optional fieldbus interfaces of the MQ.. type are based
on the same housing and fieldbus technology as type MF…
fieldbus interfaces, but are additionally equipped with an
integrated controller featuring the following functions:
- Programmable
- Simple positioning with NV26 or ES16 proximity sensors
- Integrated I/O preprocessing and timing elements
- Protocol modification
Options for MF../MQ.. fieldbus interfaces
|
Options for MF../MQ.. fieldbus
interfaces
|
|
MFG11A keypad
|
|
The MFG11A keypad is plugged onto any MFZ..
connection module instead of a fieldbus interface
for manual control of a MOVIMOT® drive.
|
|
DBG60B keypad
|
|
The DBG60B keypad can be used to control MOVIMOT®
drives via a fieldbus interface in manual mode.
The process data words can also be displayed in
monitor mode.
The DBG60B keypad is connected directly to the
diagnostic interface of the MF..MQ.. fieldbus
interface.
|
Hybrid cables for decentralized installation
Our hybrid cables were developed in-house and are
combination cables that carry the power supply, control
voltage and communication strands in one cable sheath. They
also ensure optimum EMC shielding and impedance. The hybrid
cable for connecting MOVIMOT® to field
distributors combines the communication interface and supply
and control voltage connections in one cable and is supplied
as a pre-fabricated cable with a plug connection. MOVIMOT®
drives with attached hybrid cables are easy to connect to
field distributors and ready for use. They are ideal for all
systems with high demands on availability.
|
Send us an email
Send us a fax
Call us
