|
|
Brake Control System
BEM / URM
|
|
MOVIMOT® can be equipped with a BEM or URM brake
control system as an option in conjunction with a
modular terminal box. The option is integrated in
the MOVIMOT® terminal box.
|
Braking resistor
BW100... / BW200...
|
|
The BW100.../BW200... braking resistors in IP65
enclosure convert the MOVIMOT®
drive’s regenerative energy of up to 100 W/200 W
continuous power into heat.
|
Braking resistor
+BW150... / BW068...
|
|
The BW150.../BW068.. braking resistors in IP66
enclosure convert the MOVIMOT®
drive’s regenerative energy of up to 600 W/1200
W continuous power into heat.
|
DC 24 V power supply MLU11A
|
|
The optional DC 24 V power supply MLU11A is
mounted in a MOVIMOT® cable gland and
allows for operation of one MOVIMOT®
including an option with a current consumption of
up to 70 mA (MBG11A, MWA21A) without an external
24 V auxiliary power supply.
|
DC 24 V power supply MLU13A
|
|
The optional DC 24 V power supply MLU13A is
mounted in the MOVIMOT® terminal box
and allows for operation of one MOVIMOT®
including an option with a current consumption of
up to 70 mA (MBG11A, MWA21A) without an external
24V auxiliary power supply.
|
MLG setpoint control module
|
|
The optional MLG..A setpoint generator is mounted
in a cable gland of MOVIMOT® and
offers the option of adjusting the input speed in
the range of -100% to +100 % fmax
(potentiometer f1) as well as of powering the
inverter with the DC 24 V auxiliary voltage.
|
MBG11A setpoint control module
|
|
The optional MBG11A setpoint control module has
two keys and a display. MBG11A.. makes it possible
to adjust the speed remotely in the range from
-100% to +100% fmax (potentiometer f1).
Up to 31 MOVIMOT® units can be
controlled at the same time (broadcasting).
|
MWA21A setpoint converter
|
|
The optional MWA21A setpoint converter converts an
analog setpoint and the control signals into an
RS-485 protocol. The MWA21A enables the MOVIMOT®
to be controlled remotely from the control
cabinet. Up to 31 MOVIMOT® units can
be controlled at the same time (broadcasting).
|
|
|
|
The DBG60B keypad can be used to control MOVIMOT®
drives with integrated AS interface in manual
mode. Furthermore, important information can be
displayed in monitor mode.
The DBG60B keypad is connected to the diagnostic
interface in the MOVIMOT® terminal
box.
|
|
|
|
The optional MDG11A diagnostic unit indicates the
operating status, output current, terminal
statuses and MOVIMOT® fault codes when
faults occur.
|
|
|
|
The MNF11A line filter option is mounted in the
MOVIMOT® terminal box and allows for a
drive system that complies with the emitted
interference stipulated in EN 61800-3 as well
as with the class B limit according to EN 55011
and EN 55014.
|
P2.A mount for mounting near motor
|
|
The P2.A option allows the MOVIMOT®
inverter to be mounted near the motor (offset).
The inverter is connected to the motor using a
pre-fabricated hybrid cable. MOVIMOT®
with option P2.A is supplied in enclosure IP65.
|
Send us an email
Send us a fax
Call us
